Updating Italian Design Guide CNR DT-205/2007 in View of Recent Research Findings: Requirements for Pultruded FRP Profiles
Fabio Minghini1, Nerio Tullini1 & Francesco Ascione2 Show affiliations
- University of Ferrara, Italy
- University of Salerno, Italy
American Journal of Engineering and Applied Sciences, Volume 9, Issue 3, pp. 702–712 · doi.org/10.3844/ajeassp.2016.702.712
Abstract
A discussion on some design rules for pultruded fiber-reinforced plastic (PFRP) profiles reported by guideline CNR DT-205/2007 from National Research Council of Italy is presented in the paper. At eight years after approval of this technical document, several changes and improvements are required following recent research findings and supplemental design rules should be incorporated into a future revision. The general framework for the design of columns and beams is outlined. A new closed-form expression for the local buckling moment for beams in major-axis bending is presented.
Licence and reuse
Open access. This article is licensed under a Creative Commons Attribution 3.0 Licence (CC BY 3.0), as printed on the article, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original authors and the source. No permission is needed.
How to reuse this articleResponses (0)
About this article
Minghini, F., Tullini, N. & Ascione, F. (2016). Updating Italian Design Guide CNR DT-205/2007 in View of Recent Research Findings: Requirements for Pultruded FRP Profiles. American Journal of Engineering and Applied Sciences, 9(3), 702–712. https://doi.org/10.3844/ajeassp.2016.702.712
- Licence
- CC BY 3.0
- Issue
- Volume 9, Issue 3
- Policies
- Editorial independenceUse of generative AIData availabilityAppeals and complaints
- Version
- Version of record