Polyethylene Pipeline Bending Stresses at an Installation
Anatoly Serebrennikov1, Daniil Serebrennikov1 & Zufar Hakimov1 Show affiliations
- Tyumen State Oil and Gas University, Russia
American Journal of Engineering and Applied Sciences, Volume 9, Issue 2, pp. 350–355 · doi.org/10.3844/ajeassp.2016.350.355
Abstract
A polyethylene pipeline trenchless installation with special machines is one of methods of gas pipeline constructions between localities. A polyethylene pipeline is exposed to a short term bend and a significant deformation during an installation. The methods and research results of the polyethylene pipeline ability at the short term bending are presented below. The mathematical model has been created. The analytical calculations of the polyethylene pipeline stress state at the bend have been done and experimentally verified. The requirements have been formulated to ensure the necessary installed pipeline operation properties.
Licence and reuse
Open access. This article is licensed under a Creative Commons Attribution 3.0 Licence (CC BY 3.0), as printed on the article, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original authors and the source. No permission is needed.
How to reuse this articleResponses (0)
About this article
Serebrennikov, A., Serebrennikov, D. & Hakimov, Z. (2016). Polyethylene Pipeline Bending Stresses at an Installation. American Journal of Engineering and Applied Sciences, 9(2), 350–355. https://doi.org/10.3844/ajeassp.2016.350.355
- Licence
- CC BY 3.0
- Issue
- Volume 9, Issue 2
- Policies
- Editorial independenceUse of generative AIData availabilityAppeals and complaints
- Version
- Version of record